Fixed setpoints – deceleration 1, 2
This menu item allows you to specify the fixed setpoints for the deceleration of drive trains 1 and 2.
INFORMATION
In the factory setting, only the application limits are effective. For the fixed setpoints to take effect, you must change the parameter Maximum deceleration – source (index 8377.31) to the value 2020A2 hex (fixed setpoints acceleration). For information on changing the parameter, refer to chapter Access to parameters via index.
The values can be specified with a maximum of 8 integer places and 2 decimal places in the system unit min-1.
7-segment display | Parameters | Index |
|---|---|---|
| Application limit – deceleration DT1 | 8357.13 |
| Fixed setpoint – deceleration 1 DT1 | 8354.50 |
| Fixed setpoint – deceleration 2 DT1 | 8354.52 |
| Application limit – deceleration DT2 | 8358.13 |
| Fixed setpoint – deceleration 1 DT2 | 8354.51 |
| Fixed setpoint – deceleration 2 DT2 | 8354.53 |
