Gateway

If the keypad is connected to a MOVITRAC^® gateway, the device selection is always displayed as the start view. The 1st tab shows the gateway, while tabs 2 – 8 show the connected inverter. Only as many tabs are displayed as there are connected inverters.

You have the following operating options:

• Press the <OK> key to connect to the gateway.
• To switch back to the device selection, press the 4th function key <Esc>.

[1]	Device address to which the CBG21A keypad is connected. The gateway has the device address "0".
[2]	Gateway tab.
[3]	Device designation of the gateway. If the device designation is empty, the device identification is displayed.
[4]	Status of the gateway.
[5]	Connect button
[6]	Display: The MOVITRAC® gateway has no device fault.
[7]	Tabs 1 – 8 for inverters: The number corresponds to the device address of the inverter.