Terminal mode (factory setting) P1-12 = 0

For operation in terminal mode (factory setting):

• P1-12 must be set to "0" (factory setting).
• Change the input terminal configuration according to your requirements in P1-15. For the possible settings, see chapter P1-15 Digital input function selection.
• Connect a switch between terminals 1 and 2 on the user terminal block.
• Connect a potentiometer (1 k – 10 k) between terminals 5, 6 and 7. The center tap is connected to terminal 6.
• Connect terminals 12 and 13 of the STO input as described in chapter Disconnection of a single drive.
• Enable the inverter by establishing a connection between terminals 1 and 2.
• Set the speed using the potentiometer.