Messages
Display | Meaning | Measure |
|---|---|---|
| Data transfer failed | For further information, refer to chapter Data management. |
| No (valid) data set saved on CBG01A | |
| The data set originates from an inverter of another download group. | |
| Incompatible main component data set | |
| Incompatible subcomponent data set | |
| Not Ready – The inverter is not ready to start manual mode. | Check the mains supply. |
| Safety prompt when exiting manual mode or startup. Depending on the firmware version, Care (< V4.00) or Attention (as of V4.00) is displayed. | After acknowledging the message, it is possible that the connected drives could start up automatically. Make sure that this does not pose a hazard.
|
Danger! Danger due to unexpected startup. Severe or fatal injuries. Before confirming this message, make sure there are no persons within the range of rotating parts.