Parameter group 9: User-defined function assignment of digital inputs (level 3)
The purpose of parameter group 9 is to give the user full flexibility to control the inverter behavior in complex applications that require specific parameter settings. Use the parameters of this group with utmost care. Only users that are absolutely familiar with the use of the inverter and its control functions should adjust the parameters of this group.
Additional information
- Overview of functions
- Logic source selection parameters
- Setpoint source selection parameters
- P9-01 Enable input source
- P9-02 Rapid stop input source
- P9-03 Input source for clockwise rotation (CW)
- P9-04 Input source for counterclockwise rotation (CCW)
- P9-05 Latch function enable
- P9-06 Direction of rotation reversal
- P9-07 Reset input source
- P9-08 External fault input source
- P9-09 Terminal control enable source
- P9-10 – P9-17 Setpoint source
- P9-10 Setpoint source 1
- P9-11 Setpoint source 2
- P9-12 Setpoint source 3
- P9-13 Setpoint source 4
- P9-14 Setpoint source 5
- P9-15 Setpoint source 6
- P9-16 Setpoint source 7
- P9-17 Setpoint source 8
- P9-18 – P9-20 Setpoint source selection input
- P9-18 Input 0 for setpoint source selection
- P9-19 Input 1 for setpoint source selection
- P9-20 Input 2 for setpoint source selection
- P9-21 to P9-23 Preset fixed setpoint speed input
- P9-21 Input 0 for preset fixed setpoint speed selection
- P9-22 Input 1 for preset fixed setpoint speed selection
- P9-23 Input 2 for preset fixed setpoint speed selection
- P9-24 Positive jog mode input
- P9-25 Negative jog mode input
- P9-26 Reference travel enable input (LTX parameter)
- P9-27 Reference cam input (LTX parameter)
- P9-28 Motor potentiometer up input source
- P9-29 Motor potentiometer down input source
- P9-30 Positive limit switch CW
- P9-31 Negative limit switch CCW
- P9-32 Selection of deceleration ramp/rapid stop ramp
- P9-33 Fire mode/emergency mode input selection
- P9-34 PID fixed setpoint reference selection input 0
- P9-35 PID fixed setpoint reference selection input 1
