TANGOF Switching off tangential control for the specified slave axis / deactivating tangential following

Deactivates the tangential control. The "Slave axis" parameter is expected during the import, but ignored in the SRL program. The address letters of the Cartesian positions (X, Y, Z, A, B, C) are allowed as the slave axis.

INFORMATION: The "Slave axis" in tangential control is defined by the principle plane. In G-code, this must be specified by TANG or the G17 (XY), G18 (ZX) or G19 (YZ) commands.

Syntax: Observe Note on the syntax explanation

TANGOF (<Slave axis : (X,Y,Z,A,B,C)>)

Example:

TANGON(X)

Implementation in the SRL program:

SET_TANGENTIAL_PARAActivate tangential control := false