Setting in speed mode

You can move the drive using manual mode.

Proceed as follows:

  1. Select Drive train optimization > Controller dynamics > Set in speed mode in the menu.
    • The following query is displayed: "Do you want to start manual mode?"
  2. Press the <OK> key.
  3. Select the value or the stiffness scale and press the <OK> key. Enter the value or set the desired value using the <right/left> arrow keys.
  4. Press the <OK> key.
  5. Select the zero clearance scale and press the <OK> key. Use the <right/left> arrow keys to set the desired value.
  6. To confirm the value, press the <OK> key.
  1. To stop manual mode, press the <Esc> key.
    • The following query is displayed: Do you want to stop manual mode? Warning! An applied setpoint will be active again after stopping manual mode.
  2. Before stopping manual mode, check that there are no persons in the area of rotating parts.
  3. Confirm with the <OK> key.
  • Manual mode has been stopped and pending setpoints become active again.
  1. To exit the menu, press the <ESC> key.
  • You have set the controller dynamics.

INFORMATION

You can also optimize the drive train using the manual modes load cycling and cycle mode. The procedure is comparable to speed mode.