Startup at a CCU

Before taking the inverter into operation with "Drive Startup" in MotionStudio, you have to set the following parameters directly on the inverter:

• Set parameter P1-14 to "1" to obtain access to the LTX-specific parameter group P1-01 – P1-20.
• If a HIPERFACE^® encoder is connected to the encoder card, then P1-16 must indicate the proper motor type. If not, select the proper motor type using the <Up> and <Down> keys.
• Assign a unique inverter address in P1-19. Changing these parameters will directly affect parameters P5-01 and P5-02.
• Set the SBus baud rate (P1-20) to 500 kBaud.