Drive project engineering for robots

The software module supports simulating the drive loads and exporting this data to the SEW-Workbench for selecting the drives for the robot. The goal of robot drive project planning is to find suitable gearmotors for the respective application.

Correct project planning for the drives requires knowledge of SEW-Workbench and the software module. Contact SEW‑EURODRIVE Service for support.

• Requirements
• Project planning procedure
• Startup of MOVIKIT® Robotics with physics simulation
• Exporting loads from the MOVI-C® CONTROLLER
• Determination of the static torque for each drive
• Importing loads into SEW-Workbench