P8-09 Velocity precontrol gain

Setting range: 0 – 100 – 400%

Defines the command source for using terminal mode.

This parameter takes effect only when P1-12 > 0. It allows the control signal source defined in P1-12 to be overwritten.

High: The sources defined in parameters P9-02 to P9-07 control the inverter.

Low: The control signal source set in P1-12 is effective.

The control signal sources of the inverter are prioritized as follows:

• STO deactivation
• External fault
• Rapid stop
• Enable
• P9-09
• Run forward/run reverse/reverse
• Reset