Static inverter status
The following list shows the status messages for a non-enabled inverter.
|
Message |
Description |
|---|---|
|
StoP |
Power section of inverter disabled. This message is displayed when the motor is at standstill and no error is present. The inverter is ready for normal operation. The inverter is not enabled. |
|
P-deF |
Parameter factory settings have been loaded. This message appears when the user issues the command for loading the parameter factory settings. To put the inverter into operation again, press the <Stop/reset> key. |
|
Standby |
The inverter is in standby mode. This message is displayed when the inverter runs at the minimum speed for the time parameterized in P2-27 and the speed setpoint is also 0. |
|
Inhibit/ Inhibit |
Is displayed when 24 V and/or GND are not present at the STO contacts. The output stage is inhibited. |
|
ETL 24 |
External 24 V voltage supply is connected. The functions are limited, see also chapter 24 V backup voltage connection. |
