Process output data

Process output data is sent from the higher-level controller to the MOVIMOT^® inverter (control information and setpoints). However, they only become effective in the MOVIMOT^® inverter if the RS485 address in MOVIMOT^® (DIP switches S1/1 to S1/4) is set to a value other than 0.

The higher-level controller controls the MOVIMOT^® drive using the following process output data:

• PO1: Control word
• PO2: Speed [%] (setpoint)
• PO3: Ramp (only for 3-word protocol)

1) Recommendation for all bits that are not assigned = "0"

• Control word, bit 0 – 2
• Control word, bit 6 = reset
• Control word, bit 8 = release brake without drive enable
• Control word, bit 9 = apply brake when control command "Stop" is issued
• Speed [%]
• Ramp