MOVISUITE^®

To configure the CIP Safety™ communication in MOVISUITE^® using the integrated "Assist CS..." software tool, you must perform the following steps.

1. Scan the device.
2. Right-click the upper half of the device. In the "Tools" context menu, select the software tool "Assist CS..".
3. 
4. Log in to the device. To do so, read out the ID of the safety key.
5. 
6. Make sure you are connected with the correct device. To do this, check the LED flashing pattern of the corresponding device.
7. Enter the password and log in. When logging in for the first time, you must enter the password twice.
8. To enable CIP Safety™ communication, first go to "F-communication".
9. 
10. Select the entry "CIP Safety" under "Protocol type". Then set the mode for address assignment to "Via CIP".
11. 
12. After completing the complete configuration, download the parameters to the safety option. Perform a transfer when the configuration is complete.