Setting absolute or relative coordinates
INFORMATION
When the program starts, the values of the basic state are automatically set for the parameters. See also Establishing the basic state.
Assignment used to set the absolute or relative coordinates for the next motion commands.
"New Block" value: "SET_ABS_REL_POS"
[1] | Selection of coordinates to be set – TargetPos – target position of the motion command (default setting: ABSOLUTE) – CircAuxPos – auxiliary point for entering a circle command. This is the circle center or a point on the circular arc, depending on the circle mode (default setting: RELATIVE) |
[2] | Drop-down list for replacing [1] |
[3] | Value to be assigned. ABSOLUTE – absolute position in the current coordinate system RELATIVE – position relative to the initial position of the path segment |
[4] | Drop-down list for replacing [3] |
