Saving an SRL program
INFORMATION
If you do not save programs and variables, the changes made are lost and cannot be restored when resetting or rebooting the controller, when generating the IEC project, or when updating the configuration data. Unsaved changes to programs or variables are indicated by a yellow dot on the [Save] button (diskette symbol).
- Click the [Save] button (diskette symbol).
- All programs and variables including motion sets of the robot are stored permanently. This means that the created programs and variables are reloaded after switching off or on the MOVI‑C® CONTROLLER or after resetting the control program. The data is saved in files on the memory card of the MOVI‑C® CONTROLLER and are read-in again when the MOVI-C® CONTROLLER is started again.
