Mounting the support plates

For stability when mounting the MOVI-DPS® storage unit on the wall, you must fit the two support plates to the MOVI-DPS® storage unit.

Mount the support plates on the two connecting pieces of the MOVI-DPS® storage unit as close to the center as possible.

  1. To do so, secure the support plates [2] with 2 M5 × 8 countersunk screws [1] each to the connecting pieces [3] of the MOVI-DPS® storage unit. Observe the maximum tightening torque of 3.2 Nm.

[1]

Countersunk screws M5 × 8 (4×)

[2]

Support plates (2×)

[3]

Connecting piece (number depends on the type of the MOVI‑DPS® storage unit)