Mounting the fastening plates

  1. To fasten the MOVI-DPS® storage unit to the wall, you must first mount the fastening plates.
  2. Hold the fastening plates against the rear of the MOVI-DPS® storage unit as shown in the figure. Use the following bores depending on the type of the MOVI-DPS® storage unit:

[1]

Holes for EKS...A‑...025M...SP..‑00 (8×)

[2]

Holes for EKS...A‑...100M...SP..‑00 (8×)

[3]

Holes for EKS...A‑...350M...SP..‑00 (8×)

  1. Mount the fastening plates by securing the 4 M5 x 8 countersunk screws in the corresponding 4 holes. Observe the maximum tightening torque of 3.2 Nm.