Applying inverter to MOVISUITE®

The MOVIDRIVE® technology application inverter is detected during the network scan.

Proceed as follows:

  • You have started a network scan.
  1. Add the scanned device in MOVISUITE®.
  2. If necessary, load the device data into the MOVISUITE® project. Confirm the message stating that the device data has been successfully applied.
    • The device is displayed in one of the MOVISUITE® views. The display depends on the view you used when closing MOVISUITE® for the last time:
    • The function view provides an overview of the entire project.
    • The combined network and function view shows all connected devices detected during the network scan.
  3. To toggle between the MOVISUITE® views, click the "Network" tab.
  4. Enter a name for the inverter. The inverter will be displayed under this name in the MOVISUITE® project. This designation is also used automatically as the PROFINET device name. Observe the specific characteristics of the PROFINET device name (see PROFINET device name).