Configuration in LT Shell

The engineering tasks for MOVITRAC® LTE-B+ and MOVITRAC® LTP-B units are performed using the LT Shell software. The USM21A interface adapter is also configured in LT Shell.

Proceed as follows:

  • You have installed the required version of the engineering software on the engineering PC. For information on the required version, refer to Requirements.
  • You have not started an engineering software on the engineering PC.
  1. Start LT Shell.
    • The main window opens.
  2. To configure the communication connection, click [1] in the toolbar.
    • The "Communication setting" window opens.
  3. Select "Wired serial interface (RS485/RS232)" from the "Select connection type" drop-down list.
  4. In the "Select COM port" drop-down list, select the port of the engineering PC to which the interface adapter is connected.
  5. Click the [Connect] button.
    • The "Communication setting" window closes.
  6. Perform a network scan.