Startup/operation
Do not deactivate monitoring and protection devices even for a test run.
When in doubt, switch off the device whenever changes occur in relation to normal operation (e.g. increased temperatures, noise, oscillation). Determine the cause of the fault and consult SEW-EURODRIVE, if necessary.
Where required, systems in which such devices are installed must be equipped with additional monitoring and protection devices in accordance with the respective applicable safety regulations, e.g. the law governing technical work equipment, accident prevention regulations, etc.
Additional protective measures may be required for applications with increased hazard potential. Be sure to check the effectiveness of the protection devices after every modification.
All connectors must be connected when operating the MOVI‑DPS® storage bundle. Make sure that no connector of the MOVI‑DPS® storage bundle is unoccupied.
Risk of burns due to arcing: Do not disconnect power connections during operation. Do not connect power connections during operation.
