Startup
WARNING
Risk of injury if the device starts up unintentionally.
There are hazards involved in using the stepper.
Risk of death or serious injuries.
- Take additional safety precautions depending on the application to avoid injury to people and damage to machinery.
INFORMATION
Make sure that the module is always supplied with the appropriate parameters for the selected operating mode! Pay particular attention to the current values used in the output area!
The system can be started up in two different ways.
Startup with the "MOVIKIT® Custom 0013" software module
The "MOVIKIT® Custom 0013" software module is an IEC function block for easy startup of the Format-Changing Drive System from SEW-EURODRIVE. It allows you to write and read parameters of the OSS21C stepper motor module and control the stepper motor via process data. For information on startup, refer to the "Software module MOVIKIT® Custom 0013 stepper motor module" manual.
Startup without the "MOVIKIT® Custom 0013" software module
For information on startup without the "MOVIKIT® Custom 0013" software module, refer to the "MOVI-PLC® I/O System C" manual.
