Installing the modules

The following figure shows an example of the procedure for installation of the modules in the control cabinet:

[1]

Retaining screws at bottom

[2]

Retaining screws on top

The retaining screws [1] and [2] are screwed into the prepared mounting grid in the control cabinet but not tightened.

Proceed as follows:

  1. Do not touch the modules on the plastic parts when lifting them.
  2. Place the module with the slotted holes on the unit base plate onto the retaining screws [1] from the top.
  3. Push the module backwards to insert the retaining screws [2] into the upper holes in the device base plate.
  4. Lower the module.
  5. Tighten the retaining screws [1] and [2].