Replacing the inverter

The MOVI-C^® system stores the applicative data set of the inverter and the data set of the safety option on the memory module in the inverter.

To replace the inverter, you must perform the following steps:

1. Switch off the device to be replaced.
2. Open the screw fitting of the inverter. Remove the plugged-in memory module from the inverter.
3. Replace the inverter (including the MOVISAFE^® CS..A safety option).
4. Insert the memory module that was removed in step 2 into the new inverter. Install the inverter.
5. Switch on the device again. Carry out a functional test. The checking of all parameters is omitted.

The inverter replacement is detected automatically and the application-related data set is loaded from the memory module into the MOVISAFE^® CS..A safety option. The MOVISAFE^® CS..A safety option is subsequently in the same state that it was in before the inverter was replaced. This means that the MOVISAFE^® CS..A safety option will be in the "Accepted" state again afterwards if it was in the "Accepted" state before the inverter was replaced. A function test of the safety option is required after the inverter replacement.