Minimum clearance and mounting position

When installing the modules in the control cabinet, observe the following:

• To ensure unobstructed cooling, leave a minimum clearance of 100 mm above and below the module housings. Make sure air circulation in the clearance is not impaired by cables or other installation equipment.
• Make sure that the devices are not subjected to heated exhaust air from nearby components.
• The axis system must be assembled without gaps.
• Install the modules only vertically. You must not install them horizontally, tilted or upside down.

INFORMATION

Special bending spaces are required according to EN 61800‑5‑1 for cables with a cross section of 10 mm² and larger. This means the clearance must be increased if required.