Procedure

  • The device dimensions X1 and Y2 can be found in the product manual > chapter Technical data > "Dimension drawings".
  • The bore dimension X2 for the tapped holes or through bores in the holding fixture can be derived from the housing dimension X1 ‑ 30 mm.
  • The bore dimension Y2 for the tapped holes or through bores in the holding fixture can be derived from the housing dimension Y1 - 30 mm.
  1. Mark the bores on the mounting surface [1].
  2. Drill the tapped holes (A) or the through bores (B).
  3. Screw the device onto the mounting surface [1] using either M6 screws (A) or M8 screws (B).