Installing shield plate for sizes 3 and 4

Proceed as follows:

The shield plate allows installation for motor, brake and braking resistor cables.

The retaining screws [1] and [2] are screwed into the prepared tapped holes in the mounting plate in the control cabinet but are not tightened.

  1. Place the inverter with the slotted holes in the device base plate onto the retaining screws [1] from the top.
  2. Push the inverter backwards to insert the retaining screws [2] into the upper holes in the device base plate.
  3. Lower the inverter.
  4. Install the shield plate [3] as shown above.
  5. Tighten the retaining screws [1] and [2].