Clarification of
- Technical data and requirements
- Boundary conditions
- System interfacing
|
↓ |
Calculation of the relevant application data
- Stationary, dynamic, regenerative power
- Speeds
|
↓ |
Gear unit selection
Determining
- Gear unit design, gear unit size, gear unit ratio
Check for gear unit utilization (Mamax ≥ Ma(t)) |
↓ |
Motor selection
- Convert torque and speed for the motor shaft
- Define the motor
|
↓ |
Check
- Max. torque which can occur Mmax < 1.5 × MN
- Required motor speed < nN
- Thermal load with regard for the setting range and cyclic duration factor
|
↓ |
Selection of theMOVITRAC® LTP-B frequency inverter
- Motor/inverter assignment
- Continuous power, peak power
- Installation conditions
|
↓ |
Selection of the braking resistor
- On the basis of the calculated regenerative power and the cyclic duration factor
|
↓ |
Options selection
- External display, cable sets, etc.
|
↓ |
Check whether all requirements are met. |
