Replacing the SD memory card

Replace the SD memory card as follows:

  1. Observe the safety notes in chapter Creating a safe working environment.
    • Make sure the device is de-energized. The 400 V line voltage and the 24 V backup voltage must be disconnected.
  2. Loosen the screws and remove the electronics cover from the connection box.
  3. Remove the SD memory card from the electronics cover.
  4. Compare the type designation of the SD memory card.

    5. INFORMATION

    The new SD memory card must have the same type designation as the previous SD memory card.
  5. Insert the new SD memory card into the electronics cover.
  6. Check the startup of the device.
    • If required, perform startup again or load a saved startup into the device.

    INFORMATION

    The variable values stored permanently on the MOVI-C® FIELD CONTROLLER are not stored on the SD memory card by default.
    • Select one of the following procedures to store the variable values on the SD memory card:
    • Program the application (IEC program) accordingly.
    • Load the data backup into the MOVISUITE® engineering software via the project management function (in preparation).
  7. Place the electronics cover onto the connection box and screw it in place.
  8. Supply the device with voltage.
  9. Check the functionality of the new electronics cover.