System bus cable
The system bus cable is used to connect the devices with the EtherCAT®/SBUSPLUS interface.
The RJ45 connectors and the socket contacts in the inverters have been checked for mechanical stability and contact reliability by SEW‑EURODRIVE. SEW‑EURODRIVE recommends using the cables listed below. If other cables and connectors are used, SEW‑EURODRIVE makes no statement about the quality of the plug-in connection.
NOTICE
Using the wrong cables.
Inverter damage.
The system bus cables may only be designed with RJ45 connectors with 4-pin assignment. When using an RJ45 connector with 8-pin assignment at this point, malfunctions or defects may occur at the connected devices.
When RJ45 cables are being used, it must be ensured that the RJ45 connectors are equipped with all contacts.
Additional information
