Loading the source file onto the MOVI-C® CONTROLLER

First load the source file with the curve point table into the corresponding directory on the memory card of the MOVI-C® CONTROLLER. To do so, use the file management of the MOVI-C® CONTROLLER in the IEC Editor.

Proceed as follows to upload the source file:

  • There is a connection between engineering PC and MOVI-C® CONTROLLER.
  • A source file with a suitable curve point table is available. See chapter Curve point table.
  1. Under "Devices", open the configuration of the MOVI-C® CONTROLLER.
  2. In the configuration of the MOVI-C® CONTROLLER, open the "Files" tab.
  3. In the "Runtime system" system, click the [Update] button.
    • The file system on the MOVI-C® CONTROLLER is displayed.
  4. Navigate in the file system on the MOVI-C® CONTROLLER to the required target folder: DATA/Camming/Achsname (Achsname = axis name).
  5. In the "Host" section, navigate to the directory that contains your source file.
  6. Select your source file in the "Host" section.
  7. Click the [>>] button between the "Host" and "Runtime system" sections.
  • The source file has now been uploaded to the MOVI-C® CONTROLLER.