Cycle times
The cycle times listed as follows will result depending on which hardware and software components are used. These cycle times must be set on the MOVI‑C® CONTROLLER and/or on the inverters. For information on how to set the cycle time, refer to chapter Setting the cycle time.
The following specifications apply with regard to the software used:
- When the software module is being used, the cycle time on the MOVI‑C® CONTROLLER and the inverters should generally be set to ≤ 2 ms.
- When using the MOVIKIT® add‑on AntiSway, set the cycle time on the MOVI-C® CONTROLLER and on the inverters to ≤ 2 ms.
If you want to use other cycle times, contact SEW‑EURODRIVE Service.
