Drive ID module

The pluggable drive ID module is installed in the basic unit.

The following figure shows the Drive ID module and its position in the MOVIMOT^® inverter.

[1]	Drive ID module

The drive ID module contains a memory module on which the following information is saved:

• Motor data
• Brake data
• User parameter

If a MOVIMOT^® inverter has to be replaced, you can re-startup the system by simply re-plugging the Drive ID module without a PC/laptop or data backup.

If, during a device replacement

• the DIP switch setting is not transmitted correctly,
• or a MOVIMOT^® inverter with a different part number is used (e.g. with a different device power),

the MOVIMOT^® inverter detects a change in configuration. This may reinitialize certain startup parameters.

This is why the MOVIMOT^® inverter must only be replaced with a MOVIMOT^® inverter with the same part number.

For information on device replacement, refer to chapter Unit replacement.