Assembly

1. Remove a screw plug on the MOVIMOT^® connection box.
2. Fix the lower part [5] on the MOVIMOT^® connection box. Secure it with a transit bolt [4] (tightening torque 2.5 Nm).
3. Route the connection cable [3] through the transit bolt [4] into the inside of the MOVIMOT^® connection box.
4. Fit the upper part [2] onto the lower part [5] and secure it with two screws [1] (tightening torque 0.9 to 1.1 Nm).

Only install the option in the following position:

For information on connecting the MLU11A/MLU21A option, refer to chapter Connection of MLU11A/MLU21A option.

For more information about connecting the MLG..A option, refer to chapter Connection of MLG..A option.