Control via terminals

Analog setpoints and fixed setpoints can be used for control via terminals. If no MOVIKIT® has been loaded ex-works, the source is set to "No source" under "Setpoints/basic setting" and the inverter can be controlled via terminals. The following default setting/factory setting applies here:

  • Digital inputs
    • DI01: FCB58 – Supply and regenerative mode
    • DI02: Fault reset
    • DI03: FCB53 – Hold precharge
    • DI04: Inhibit energy recovery function
    • DI05: No function
    • DI06: no function
  • Digital outputs
  • DO00: DC link ready
  • DO01: Precharging active
  • DO02: No function
  • DO03: Fault