MDR9.B supply and regenerative modules

The shield plate for the power cables is installed on the shield plate fastening on the bottom of the module. The shield plate is additionally supported by struts.

[1]

Retaining screws for power supply module

[2]

Retaining screws for shield plate

[3]

Shield plate fastening

[4]

Shield plate

Installing the shield plate

Proceed as follows:

  1. Loosen the lower retaining screws [1] for fastening the supply and regenerative module to the control cabinet back panel, but do not unscrew them completely.
  2. Screw the retaining screw [2] into the shield plate fastening [3] but do not tighten it yet.
  3. Install the shield plate [4] as shown.
  4. Tighten the retaining screws of the shield plate [2].
  5. Tighten the retaining screws [1] again to secure the power supply module to the back panel of the control cabinet and to secure the strut.