G54 – Selection of workpiece coordinate system selection (user coordinate system) / modal enabling of programmed shifts

The user coordinate system is selected. All absolutely programmed coordinates (e.g. X, Y, Z, A, B, C) refer only to the user coordinate system. In the SRL program, the piece coordinate system is called the user coordinate system.

INFORMATION: In the SRL program, only one user coordinate system that is selected by this command is implemented in the latest version of the software.

Syntax: Observe Notation of the command syntax

G54

Example:

G54

Implementation in the SRL program:

SET_COORDSYS Coordinate System := User