Parameter group 87. Process data parameter setting
For further information, refer to the manual "MOVITRAC® B communication"
You can use P870 – P872 to define the content of process output data words PO1 – PO3. This definition is necessary so MOVITRAC® B can allocate the appropriate setpoints.
The following PO assignments are available:
Response | Description |
|---|---|
0 / No function | The content of the process output data word is ignored |
1 / Setpoint speed | Speed setpoint entry in rpm. |
5 / Max. speed | Maximum speed (P302) |
8 / Ramp | Ramp time for setpoint selection (P130 / P131). |
9 / Control word 1 | Control signals for start/stop, etc. |
10 / Control word 2 | Control signals for start/stop, etc. |
11 / Setpoint speed % | Selection of a speed setpoint in % of P302 |
12 / IPOS® PO data | Specification of a 16-bit coded value for IPOSplus® |
13 / PI controller setpoint % | PI controller setpoint |
