P802 Factory setting

No (do not restore factory setting)

Std / standard (restore factory setting)

All / delivery status (for starting up IEC motors)

NEMA / delivery status (for starting up NEMA motors)

You can use P802 factory setting to restore the factory setting stored in the EEPROM for almost all parameters.

Activating the factory setting causes almost all parameter values to be overwritten. Save the set values using MOVITOOLS^® MotionStudio before you restore the factory settings. Once the factory setting function has been used, you must adapt the parameter values and terminal assignments in accordance with the requirements.

Statistic data must be reset separately with P804 Reset statistic data. Setting the parameter to "yes" will restore the factory settings. During this time, the display shows SEt. The previous operating state of the inverter appears on the display after the factory settings have been restored. P802 factory setting is reset to "no" automatically.

Select the delivery condition to reset all the parameters.