Connection box and electronics cover (internal) MMF31 design
The following figure shows the connection box and the bottom side of the electronics cover:
[1] | Cable glands | [10] | Engineering interface |
[2] | Screws for PE connection | [11] | MOVILINK® DDI connection |
[3] | Connection line L1, L2, L3 | [12]
| Fieldbus connection (depends on the configured connections)
|
[4] | Connection box | ||
[5] | Braking resistor connection | [13] | Connection for motor, brake and temperature sensor |
[6] | Electronics terminal strip | [14] | Electronics cover |
[7] | Maintenance switch | [15] | DIP switches S1/1 – S1/4 |
[8] | Front module | [16] | DIP switches S2/1 – S2/4 |
[9] | Plug connector connection unit for electronics cover | [17] | Replaceable memory module |
[18] | Electronics cover nameplate |
