Standby mode

The energy-saving function standby operation is designed for periods in which the operation is paused.

If necessary, activate standby operation with a binary input or a bit of the control word.

Switching from standby operation to operation takes only approx. 500 ms. This is the main difference to switching off the DC 24 V supply voltage. This short changeover time reduces energy consumption even in short pauses.

The following functions are deactivated in standby mode:

• Power section control
• Fan of the power heat sink (if present)
• Binary outputs
• STO function
• CBG functions (display: "standby operation")
• Changing parameters
• Updating the firmware
• Reset to delivery state
• Drive and motor startup
• Optional:
• Switch off the supply of the encoder and the safety card
• Encoder evaluation

The bus communication remains active without restrictions in standby operation.