Configuration general

[1]

Optionally define a scaling factor for the translational coordinates (X, Y, Z) and for the circle center (I, J, K). The function can also be used to convert from other units of measurement (e.g. inch to mm).

[2]

Optionally define a scaling factor for rotational coordinates (A, B, C). The function can also be used to convert from other units of measurement (e.g. gon to degrees).

[3]

Optionally define a scaling factor for all speed and feed settings (in the ISO code letter F). This factor can be used, for example, to convert the speed unit of the G-code used into the unit used by the software module, e.g. inch/s to mm/s.

[4]

Activate to insert a SET_MOTIONSET command to select the motion parameter set (MotionSet) at the beginning of the SRL program when importing the G-code. MotionSets are a specific property of the software module without a G-code equivalent. This setting should be activated if the imported G-code is intended to be a standalone executable.

[5]

Select a preconfigured MotionSet.

[6]

Activate to insert a SET_BLENDING_PARA command for defining the blending distance at the beginning of the SRL program when importing the G-code. The blending distance setting is a specific feature of the software module without G‑code equivalent. This setting should be activated if it is intended for the imported G-code to use the blending (path control operation). In the basic state of the interpreter, blending is switched on, a blending distance of 0 mm is set as well as the other default settings for blending. See also Establishing the basic state. Only the blending can be activated or deactivated in the G-code using the corresponding commands. A command to change the blending distance does not exist in G-code.

[7]

Define the blending distance.