Line filter installation

INFORMATION

Note that the inverter must be installed in the control cabinet before you install the line filter.

To install the line filter, proceed as follows:

  1. Remove the power plug [1] from the inverter.
  2. Unscrew both PE screws [2] from the inverter and remove the terminal boards.
  3. Place terminal boards underneath the two PE screws [2] and screw them back onto the line filter.
  4. Remove the plastic cover [3] of the line filter. To do this, grasp the recess [4] on the underside of the plastic cover and pull it off upwards.
  5. Slide the fastening plate [5] into the designated recess in the inverter housing. Fasten the plate using the 2 screws [6].
  6. Place the line filter [7] onto the inverter so that the power plug of the line filter fits into the socket contact on the inverter.
  7. Screw in the 2 retaining screws [8].
  8. Slide the plastic cover [9] onto the line filter again from above.
  9. Insert the power plug [10] into the socket contact of the line filter.
  10. Screw in the retaining screw [11] on the line filter.