Device replacement

If a device needs to be replaced, the following procedures apply:

• Using a CBG.. keypad
• When using a keypad, the parameter and configuration settings can be stored on the keypad. By plugging the keypad into another inverter and activating data transmission, data is transferred to the inverter. After the transmission is complete, the inverter is immediately ready for operation for the specific application.
• Using a MOVI-C^® CONTROLLER
• If the data management (axis data set recovery) of the MOVI-C^® CONTROLLER is used, the parameter and configuration settings of the controller are always transferred to the inverter. The data is on the memory card of the MOVI-C^® CONTROLLER. If the data management of the MOVI-C^® CONTROLLER is not active, the memory source can be set in index 8431.20 (memory source) as follows:
• 1 - Internal memory
• The inverter reads or writes the parameter and configuration settings to the internal device memory of the inverter.