Setpoint potentiometer f1

NOTICE

Loss of guaranteed degree of protection if the screw plugs on the f1 setpoint potentiometer and diagnostic interface are not installed or not installed correctly.
Damage to the MOVIMOT® inverter.
  • After setting the setpoint, make sure the screw plug of the setpoint potentiometer has a seal and screw it in.

The potentiometer f1 has different functions depending on the operating mode:

  • Binary control:

Setting setpoint f1
(f1 selected via terminal f1/f2 X6:7,8 = "0")

  • Control via RS485:

Setting maximum frequency fmax

[1]

Potentiometer setting