General information concerning startup

INFORMATION

You must comply with the general safety notes in chapter "Safety notes" during startup.

WARNING

Risk of crushing due to missing or defective protective covers.
Severe or fatal injuries.
  • Install the protective covers of the plant according to the instructions, see the operating instructions of the gear unit.
  • Never start the unit if the protective covers are not installed.

WARNING

Electric shock from capacitors that have not been fully discharged.
Severe or fatal injuries.
  • Disconnect the inverter from the power. Observe the minimum switch-off time after disconnection from the supply system:
    • 1 minute

WARNING

Device malfunction due to incorrect device setting.
Severe or fatal injuries.
  • Comply with the startup instructions.
  • The installation must be carried out by qualified personnel only.
  • Always use the appropriate functional settings.

WARNING

Danger of burns due to hot surfaces of the device (e.g. the heat sink).
Severe injuries.
  • Do not touch the device until it has cooled down sufficiently.

INFORMATION

To ensure fault-free operation, do not disconnect or connect power or signal lines during operation.

INFORMATION

  • Remove status LED paint protection cap before startup. Remove paint protection film from the nameplates before startup.
  • Observe a minimum switch-off time of 2 seconds for the K11 line contactor.