Fieldbus cables and cable routing

Proceed as follows when laying the fieldbus cables:

  1. Remove the safety cover, see chapter Removing and attaching the safety cover.
  2. Insert the two cables into the connections X40 and X41 of the device, as shown in the following example:
  3. Route the cables according to the following figures depending on the size. If necessary, use cable ties for fastening to the fastening lugs.

Size 0S

Size 0L

Size 3 – 4

From size 5

  1. Break the two plastic parts [3] out of the safety cover as shown in the following example:
  2. Attach the safety cover again.