Installing the inverter
INFORMATION
When using gateways and communication modules, all inverters must be mounted flush next to each other
Proceed as follows:
The retaining screw [1] is screwed into the prepared tapped hole in the mounting plate in the control cabinet but is not tightened.
- Place the inverter with the slotted hole in the device base plate onto the retaining screw [1] from the top.
- Push the inverter backwards to insert the retaining screw [2] into the upper hole in the device base plate and the tapped hole in the mounting plate.
- Tighten the retaining screws [1] and [2].
Observe the corresponding bore pattern if the installation takes place with the line filter attached.
To disassemble the inverter, perform the assembly steps in reverse order.
