Sizes X170 – 320
- Loosen the locking screws [10] by a quarter turn one after the other to avoid straining the connecting surface.
INFORMATION
If the outer ring (stepped tapered ring) [9a] and the inner ring (stepped tapered bushing) [9b] do not loosen by themselves: Take the necessary number of screws and screw them evenly into the disassembly bores. Tighten the locking screws in several steps until the tapered bushing separates from the tapered ring.
- Loosen the retaining screw [6].
- Remove the retaining screws [3] and remove the end plate [4].
- To protect the centering bore, screw the retaining screw [6] into the machine shaft [1].
- For disassembly of the gear unit, use the retaining screws [3] to attach the reversed end plate [4] centrically to the hollow shaft [7]. The retaining screws [3] should be tightened hand-tight.
- Thread the ejector screw [8] into the end plate [4] to remove the gear unit from the machine shaft [1]. Disassembly is easier if you first apply lubricant to the ejector screw [8] and the thread of the end plate [4].
[9a] | Outer ring (stepped tapered ring) |
[9b] | Inner ring (stepped tapered bushing) |
[10] | Locking screws |
[6] | Retaining screw |
[3] | Retaining screw |
[4] | End plate |
[1] | Machine shaft |
[6] | Retaining screw |
[3] | Retaining screw |
[4] | End plate |
[7] | Hollow shaft |
[1] | Machine shaft |
[4] | End plate |
[8] | Ejector screw |
- Thoroughly clean the removed shrink disk from dirt and the remaining adhering lubricants.
- Apply an MoS2 compound onto the threads and under the screw heads of the locking screws [10], for example "gleitmo 100" from FUCHS LUBRITECH (www.fuchs-lubritech.com).
- Apply a thin layer of an MoS2 compound onto the tapered surface, as shown in the following figure, for example "gleitmo 100" from FUCHS LUBRITECH (www.fuchs-lubritech.com).
INFORMATION
