Lubricant tables

This lubricant table is valid when the document is published. Refer to www.sew-eurodrive.de/lubricants for the latest version of the table.

This lubricant table is valid when the document is published. Refer to www.sew-eurodrive.de/lubricants for the latest version of the table.

This lubricant table is valid when the document is published. Refer to www.sew-eurodrive.de/lubricants for the latest version of the table.

1)

Lubricants may only be used
if service factor Fs and peak load factor FF ≥ 1.6.
The peak output torque MK2per is limited as follows: FF ≥ 1.6 → MK2per ≤ 1.25 × MN2 (nominal torque) → MK2per ≤ 2 × MN2/FF = 2/1.6 × MN2.
In case of deviations, contact SEW‑EURODRIVE.

2)

NSF-H1 registered oils for the food processing industry cannot be combined with the gear unit option "Extended storage" (a VCI anti-corrosion agent is added).

 

 

NOTICE:
Also observe the thermal application limits of the oil seal materials, see chapter Lubricant compatibility with oil seals.