Relubricating the bearing for Drywell sealing systems
WARNING
Risk of crushing due to rotating parts.
Severe or fatal injuries.
- Observe the 5 safety rules before commencing the work: Disconnect. Secure the device against a restart. Check that no voltage is applied. Ground and short-circuit. Cover or isolate neighboring live parts.
NOTICE
Excessive press-in pressure can cause grease to leak between the sealing lip of the oil seal and the shaft. The sealing lip can be damaged or slip.
Possible damage to property.
- Make sure that the grease drain is open and the excess used grease can escape.
INFORMATION
- Slowly turn the shaft when relubricating the bearing to ensure better distribution of the grease.
- Refer to www.sew‑eurodrive.de/lubricants for the used lubricants.
- Immediately remove any old grease that has leaked out.
Additional information
